Field Service Machinist

Perris, CA | $25-42/hr | Up to 50% travel

Manual machinist needed for a rotating equipment repair shop. This is repair and overhaul work on pumps, steam turbines, and compressors. One-off parts, not production runs.

What you'll do

• Set up and run horizontal lathes, milling machines, VTL, and Bullard
• Turning, boring, threading, facing, drilling, and milling on pump, turbine, and compressor components
• Work from blueprints, technical drawings, and work instructions
• Select your own tooling, fixtures, and materials for each setup
• Check your work with micrometers, calipers, and gauges. Tolerances to .0005"
• Inspect incoming and finished parts for wear, defects, and spec compliance
• Troubleshoot machining issues and adjust for accuracy
• Assist with disassembly, repair, and reassembly of components

What you need

• 5 to 10 years as a manual machinist
• Horizontal lathes, mills, VTL, and Bullard
• Able to read drawings and use calibrated measuring tools
• Able to hold .0005"
• High school diploma or GED
• Valid driver's license
• Able to lift 50 lbs and stand or walk most of the shift
• OMEGA experience is a plus

Details

Full time. 40 hours minimum, averaging 45. Overtime available. Up to 50% travel, domestic and international, so you'll need a current passport.

To apply, message me on LinkedIn or email James.Lake@flowtec.com.